You are using an outdated browser version not supported by this website.
Click here to upgrade your browser

InteriorInterior
Cabot's Cabothane Clear Water Based
Description

Cabot's Cabothane Clear Non-Drip Water-Based is a highly durable, low odour, non-drip clear timber varnish for interior doors, windows and furniture.

It's non-drip quality makes it ideal for interior vertical surfaces where usual clears may sag on the surface or drip off the brush for an unsatisfactory result. *

  • Sizes: 250ml, 500ml, 1L, 4L, 10L
  • Sheen: Matt, Satin, Gloss
  • Coverage: 16m²/L (depending on porosity/condition of timber)
  • Recoat Time: 2 Hours

*Product may drip off brush if heavily loaded. Product may also sag on vertical surface if excessive amount applied.

Key Features
  • Ideal for vertical surfaces
  • 2 hour recoat*
  • Non-yellowing formula**
  • Water wash up
  • Touch dry in 30 minutes*
  • Fully cured in 7 days* 

* If applied at the recommended spreading rate. Longer dry time for cooler or humid conditions. 

** Product will not prevent yellowing of substrate.

Scope of Use
  • Timber doors, windows, trim and furniture
  • Ideal for vertical surfaces
Limitations on Use
  • No sanding is required for pre-coated interior timber, preparation steps above must be followed. Please note new timber and previously coated exterior timber must be sanded
  • All timings quoted at 25°C and 50% humidity. Cooler or humid conditions may require longer
  • Do not apply this product in temperatures below 10°C or above 35°C, or when rain or heavy dew is expected during the drying period. If using outside in hot temperatures, do not apply in direct sunlight.Cool the timber by lightly dampening with water and coat in the shade
  • Cabot's Cabothane Clear is not suitable for: previously wax coated finishes walk-on areas extreme UV exposure broad wall application
  • For surfaces subject to extreme UV exposure, use Cabot's Exterior Clear
Other Performance Attributes

Maintenance:

Once the surface becomes excessively scratched and worn, it's time for a re coat.

  • 1. Thoroughly clean the surface with Cabot's Floor Clean and allow to dry
  • 2. Apply one coat to a small test area. Allow to dry for 3 hours. Press sticky tape firmly to the surface and pull off quickly. If the coating comes off, sand back further to a sound surface
Documents
Cabothane Clear Water-Based (Gloss) Product Data Sheet
Cabothane Clear Water-Based (Matt) Product Data Sheet
Cabothane Clear Water-Based (Satin) Product Data Sheet
Cabothane Clear Water-Based Safety Data Sheet
Cabot's Interior Product Guide
Cabothane Clear Water-Based Product Page

Cabot's Timber Finishes manufacture a comprehensive range of stains, varnishes, clear finishes, oils and polishes for the preservation and beautification of timber.

Product Enquiries

News from Cabot's

New Colours for Weatherboard and Fence Stain
Get a free weekly digest of essential news

New and updated architectural products, design solutions, inspiration, technical advice and more when you sign up for EBOSS.