Profix TS20 by Décortech Exteriors

Profix TS20

Description

Profix TS20 Concealed fixed flat panel façade system is a unique aluminium vertical rail system specifically designed for use with Trespa Meteon panels. TS20 offers a cost effective method for fixing Trespa Meteon panels with a vertical set out and up to a maximum height of 4.6 meters.

Profix TS20 is perfect for single storey buildings, parapets and all simple low level construction. Panels are configured vertically with either a ship-lapped vertical joint or an open jointed 10mm negative. Horizontal joints are formed with a simple horizontal shiplap that enables panels to extend to 4.6 meters high.

Profix TS20 is compliant and tested to meet the requirements of AS/NZS 4284, NZBC E2/AS1/VM1 and B2 respectively.

Available in 4 master sheet sizes
Available in 8 and 10mm thickness
Available in a large range of colours and finishes

Key Features

Profix TS20 rail system is durable, lightweight, fixed vertically over continuous framing and can span between the fixings allowing the rail to be packed straight and true
Profix TS20 offers minimal maintenance and exceptional through life performance
The Sika Tack adhesive system offers concealed fixing giving a clean, flat and straighter finish to the façade
Exposed mechanical fixings (wafer head coloured 304 stainless steel screws or coloured structural rivets) can be used
Suitable for use as a cladding solution on new buildings and facade upgrades
Supply and installation is carried out by approved installers only

Ranges

Profix Systems

Scope of Use

Suitable for use as a residential or commercial cladding façade up to 4.6 metres
Fixed over a Rigid Air Barrier or Building wrap compliant with NZBC E2/AS1/Table 23: 1 August 2011 and NZS 3604: 2011 as follows:
- With Building Wrap: Up to 'Very High' wind zone at 50 m/s or 1.5 Kpa ULS wind pressure
- With Rigid Air Barrier: Up to 'Extra High' wind zone at 55 m/s or 1.8 Kpa ULS wind pressure
For use in wind zones exceeding 1.8 Kpa wind pressure the system and fixings must be specified as site specific by the system suppliers
Suitable for use in all environments including sea spray and geothermal zones
Suitable for use with either 8.0mm or 10mm Trespa Meteon in vertical panel sizes up to 2.5m x 1.2m. The use of panel sizes exceeding 2.5m must be specified as site specific by the system suppliers

Limitations on Use

Supply and installation is carried out by approved installers only
The use of panel sizes exceeding 2.5m must be specified as site specific by the system suppliers

Statement of Building Code Compliance

Trespa Meteon panels in conjunction with Profix TS20 Cladding system meet the requirements of NZBC sections B1 Structure, B2 Durability and E2 External Moisture.