You are using an outdated browser version not supported by this website.
Click here to upgrade your browser

InteriorInterior
Intergrain UltraClear Exterior
Description

Intergrain UltraClear Exterior is a tough, clear, marine grade water based timber finish for use on window frames, doors and trims.

  • Coverage: 10m²/L
  • Recoat Time: 4 Hours
  • Sheen: Gloss & Satin
  • Sizes Available: 1L, 4L

Incorporating UV absorbers, UltraClear Exterior provides superior protection against the weather including the harmful effects of the sun’s UV radiation.

Available in gloss and satin, UltraClear Exterior has a low odour and unlike oil based coatings will not yellow. Easy to apply and fast drying, UltraClear Exterior allows for several coats to be applied in one day.

Key Features
  • Protection against weather and UV
  • Clear 
  • Non-yellowing
  • Marine-grade
  • Low odour
  • Fast drying allows for several coats to be applied in one day 
  • Water-based and so product emits less VOCs into the atmosphere*

*Compared to traditional oil-based exterior clear finishes

Scope of Use

On exterior timber doors, window frames, trims and eaves. UltraClear Exterior can also be used on the inside of exterior doors and window frames.

Note: UltraClear Exterior is not suitable for areas subject to foot traffic (such as decks and walkways) or broadwall. For these areas use Intergrain UltraDeck Timber Oil or UltraDeck Timber Stain.

Limitations on Use

Do not apply to hot surfaces or those in direct sunlight, as doing so may result in difficult application.

Do not apply in temperatures above 35°C, below 10°C or if rain or dew is expected within four hours of application. Lightly dampening timber before painting will ease application in temperatures above 28°C.

Other Performance Attributes

Maintenance

Conduct a routine 12 monthly maintenance inspection. Note: For marine environments conduct a 3 monthly maintenance inspection.

Best protection of the timber and ease of maintenance is ensured if UltraClear Exterior is recoated before deterioration of the coating and timber underneath occurs.

First indication of the need for recoating will be observed as patchiness or thinning of the surface coating on edges and areas where insufficient product has been applied.

If small areas of timber have weathered through to cause deterioration of the coating, sand affected areas back to bare timber, remove sanding dust and recoat.

For large weathered areas remove UltraClear Exterior by sanding, or use a combination of Liquid 8 Timber Stripper* and sanding.

To recoat UltraClear Exterior which is in good condition, lightly sand, remove sanding dust and apply one coat of UltraClear Exterior.

Documents
UltraClear Exterior (Gloss) Product Data Sheet
UltraClear Exterior (Satin) Product Data Sheet
UltraClear Exterior Safety Data Sheet
Intergrain Timber Finishes Guide
UltraClear Exterior Product Page

Intergrain products are high-performance, environmentally friendly timber finishes designed to protect the natural beauty of timber.

Product Enquiries

News from Intergrain

Create an Award Worthy Deck with Intergrain UltraDeck
Get a free weekly digest of essential news

New and updated architectural products, design solutions, inspiration, technical advice and more when you sign up for EBOSS.