Use on all interior timber including doors, windows, furniture and joinery. UltraClear Interior is ideal for use where maintaining the timbers natural colour is desired, especially with pale timbers such as Pine, Cedar, Macrocarpa and Timber Veneers.

Note: UltraClear Interior is not suitable for heavy wear surfaces (such as floors), for these areas use Intergrain UltraFloor

Do not apply in temperatures above 30°C or below 10°C.

Do not apply to hot surfaces or those in direct sunlight as doing so may result in difficult application and poor adhesion.

Maintenance

Clean using water and a non-abrasive household detergent.

To ensure minimum preparation when recoating, surfaces should be recoated before UltraClear Interior has worn away to expose bare timber. Clean to remove any waxes or polishes. When dry, sand to a uniform surface and wipe away dust. Apply one to two coats following application instructions.

Where UltraClear Interior has worn away to expose bare timber it must be thoroughly removed and the surface prepared as per instructions for new timber. A combination of Liquid 8 Timber Stripper* and sanding is recommended.