• Use on timber floors, parquetry, cork and other high-wear areas such as bench tops, tables and stairs

• Do not apply in temperatures above 30°C or below 10°C
• Do not apply to hot surfaces or those in direct sunlight as doing so may result in difficult application 

Maintenance

Regularly clean floors with Cabot’s Floor Clean.

Surfaces should be recoated before UltraFloor has worn away to expose bare timber. Clean to remove any waxes or polishes. When dry, sand to a uniform dull surface and wipe away dust. Apply one to two coats following application instructions.

If patches of floor have been worn back to bare timber, the coating must be fully removed by sanding and the surface prepared as per instructions for previously finished surfaces.