Glasswool Ceiling Blanket by Premier Insulation

Glasswool Ceiling Blanket

Description

Premier Glasswool is a resin-bonded thermal insulation material made using up to 90% recycled glass. It is designed for use in residential and commercial ceiling applications. Premier Glasswool carries a 50 year durability warranty.

Format: Roll form
Thicknesses: 145, 155, 175mm
Standard width: 1200mm
R-values: R3.3, R3.6, R4.1

Key Features

50 year durability warranty
BRANZ appraised
Manufactured from 90% recycled glass
Cost effective, flexible, and easy to install
Non-combustible
Select options are Eco Choice Aotearoa Certified — see Data Sheet

Ranges

Premier Glasswool Insulation

Eco Choice Aotearoa

Pre-Consumer Recycled Content

Scope of Use

Premier Glasswool provides thermal insulation for use in ceilings in both residential and commercial construction.

Double-Layer Ceiling Installations:

For higher R-value ceiling installations 'double-layer' installation is recommended to reduce thermal bridging.
The bottom layer of insulation should be same thickness as the bottom chord, ideally high-density, and installed between the trusses.
The second (top) layer should be installed tight around the trusses with joins off-set to the bottom layer of insulation.
This will ensure a full cover of insulation and reduce heat-loss through the timber.

Rolls are available in:

Thicknesses: 145, 155, 175mm
Standard width: 1200mm
R-values: R3.3, R3.6, R4.1

See Data Sheet and Installation Guide for full information.

Contact Premier Insulation for specification and H1 support.

Limitations on Use

Must be installed in accordance with Premier Insulations' installation guide and other literature
Premier Insulation should not be crushed, folded, or compressed

Premier Glasswool must be:

Installed and maintained in a dry, protected environment
Installed in a building where provisions of NZBC E2 and E3 are met
Installed to the requirements of NZS 4246:2016: Energy Efficiency-Installing bulk thermal Insulation in Residential Buildings

Statement of Building Code Compliance

Premier Glasswool is designed for the thermal insulation of buildings in accordance with the New Zealand Building Code (NZBC) H1 Energy Efficiency.

When installed in accordance with the manufacturer's instructions, Premier Glasswool will meet or contribute to meeting the following NZBC clauses:

Clause B2 DURABILITY: Performance B2.3.1 (a) not less than 50 years, B2.3.1 (b) 15 years and B2.3.2. Premier Insulation will meet these requirements.
Clause E3 INTERNAL MOISTURE: Performance E3.3.1. Premier Insulation contributes to meeting this requirement
Clause F2 HAZARDOUS BUILDING MATERIALS: Performance F2.3.1. Premier Insulation meets this requirement
Clause H1 ENERGY EFFICIENCY: Performance H1.3.1 (a) and H1.3.2 E. Premier Insulation contributes to meeting these requirements